Picnic table with umbrella are wonderful things to have in your back yard for kids and guests at the family’s cook outs. They are even better when you put large market umbrellas to them. Your shadow is always with you and there is no need to keep moving the table as the sun moves. The project uses some plumbing products that can be easily purchased anywhere. You need some basic knowledge about Tap Devices and how to use them or someone to show you how.
Instructions
Add a Market Umbrella to a picnic table
Measure the diameter of the picnic table with umbrella pole. Your pipe flange must be the size of the umbrella pole to fit through. Buy the right size screws to fit the tube flange base. Also buy the right size computer to fit inside the tube flange opening. It is best to buy these at the iron trade all at the same time, so you can be sure to match everything as you choose it.
Measure your umbrella to find the exact center. Measure the middle board lengthways and cross and mark the exact center. This is where you have to drill with whole saw to cut your round circle through the board. Fit your fittings. By the appropriate crane, make a hole in the side of the short tube. The thumb screw screws in this hole. It will lock your umbrella pole. Place the picnic table with umbrella on the side so that you have easy access to the bottom of the table. Line the floor flange up to the hole you saw in the center of the table and screw the flange into place.
